 |
Create a Pad: Click
this icon, select the profile to be extruded and enter the parameters you
need in the dialog box. |
|
Using the
Sub-elements of a Sketch: right-click the Selection field from the Pad
or Pocket dialog box and select the Go to Profile Definition contextual
command to display the Profile Definition dialog box. |
| |
Create an 'Up to Next' Pad:
Click this icon, select the profile to be extruded, set the Type option to `Up to
next' and enter the parameters you need in the dialog box. |
| |
Create an 'Up to Last' Pad:
Click this icon, select the profile to be extruded, set the Type option to `Up to
last' and enter the parameters you need in the dialog box. |
| |
Create an 'Up to Plane' Pad:
Click this icon, select the profile to be extruded, enter the parameters
you need, set the Type option to `Up to plane' in the dialog box and
select the required plane. |
| |
Create an 'Up to Surface' Pad:
Click this icon, select the profile to be extruded, enter the parameters
you need, set the Type option to Up to surface in the dialog box and
select the required surface. |
| |
Create
a Pad from a Surface:
Click this icon, select the surface to be extruded and enter the parameters
you need. |
| |
Create a Pad not Normal to Sketch Plane:
Click this icon, select the profile to be extruded, expand the dialog box,
enter the required parameters, define a new reference for the extrusion
direction. |
 |
Create a
Multi-Pad:
Click this icon, select the sketch to be extruded and specify a length
value for each domain. |
 |
Create a Drafted
Filleted Pad:
Click this icon, select the profile to be extruded and enter the parameters you need in the
dialog box. |
 |
Create a Pocket: Click
this icon, select the profile and enter the parameters you need in the
dialog box. |
| |
Create
a Pocket from a Surface:
Click this icon, select the surface to be extruded and enter the parameters
you need. |
 |
Create a
Multi-Pocket:
Click this icon, select the sketch to be extruded and specify a length
value for each domain. |
 |
Create a Drafted
Filleted Pocket:
Click this icon, select the profile to be extruded and enter the parameters you need in the
dialog box. |
|
|
Create a
Thin Solid: Click one of these icons, check the option
"Thick" and enter values to define the thickness. |
 |
Create a Shaft: Click
this icon, select the profile to be revolved about the axis and enter
angle values. |
|
Create a Groove: Click
this icon, select the profile to be revolved about the axis and enter
angle values. |
 |
Create a Hole: Click
this icon, select the face to locate the hole to be created and enter
the required parameters in the dialog box. |
| |
Create a
Threaded Hole: Click
this icon, select the face to locate the hole, define the hole shape, check
Threaded, click Specifications and enter the required values in the Thread
dialog box.. |
 |
Create a Rib: Click
this icon, select the profile to be swept along a center curve, select
this center curve and set the position option in the dialog box. |
 |
Create a Slot: Click
this icon, select the profile to be swept along a center curve, select
this center curve and set the position option in the dialog box. |
 |
Create a Stiffener:
Click this icon, select the profile to be extruded, and specify whether
this extrusion is to be done in two or three directions. |
 |
Create a Loft: Click this
icon, select the section curves, the guide curves and if necessary the
spine of your choice. |
 |
Remove Lofted Material: Click
this icon, select the section curves, the guide curves, the closing points
and if necessary the spine of your choice. |
